Laboratory Water Bath Maintenance

5 4 remove the water from the water bath and wash the water bath with purified water and mop with a clean dry cotton cloth.

Laboratory water bath maintenance.

Since almost all laboratory water bath has a digital interface to allow users to set a required temperature usually an indicator light turns on to indicate that the water bath is working. Our microprocessor controlled thermo scientific water baths provide superior temperature uniformity for your specific applications and offer unique features such as a seamless stainless steel interior chamber and epoxy coated exterior which make them resistant to corrosion and chemical damage. If you can find the user manual for the water bath you should check to see if there are any special cleaning instructions. Clean the bath with soapy water and a cloth.

Maintenance for water filled baths it is recommended that the bath is drained cleaned and re filled on a weekly basis to avoid build up of salts and contamination. 5 1 switch off the mains. Cranson adds place your bath away from high traffic doorways and out of direct sunlight. When the pan is removed for cleaning ensure the unit is unplugged.

5 2 remove the lid from the water bath. Regularly adding fresh water will replenish the oxygen which helps maintain the protective chromium oxide layer on the stainless steel. How scientists use a bath also matters. You should never use bleach in a misguided attempt to sterilize a water bath because it will corrode the stainless steel interior.

It is important to refill the bath with the right kind of water. Afterwards thoroughly rinse the bath with water to make sure no soap is left behind. Keeping the samples in place with racks also helps. 5 2 connect the power supply.

Avoid the use of chlorine containing cleaning supplies such as bleach and abrasive scrubbers because they will damage the bath and cause it to rust. Clean the empty bath with soapy water and a cloth. 5 2 ensure the water level in water bath. 5 4 switch on the main power supply and instrument mains.

5 1 ensure that the platform is dry. Maintenance for water filled baths it is recommended that the bath is drained cleaned and re filled on a weekly basis to avoid build up of salts and contamination. Some top tips include the following. Use only a damp cloth with mild detergents avoiding any corrosive cleaning agents.

Regularly adding fresh water will replenish the oxygen which helps maintain the protective chromium oxide layer on the stainless steel. Use only distilled water float the sample so the lids stay dry and keep the bath covered as much as possible. 5 3 wash the lid properly with purified water. Once the correct temperature is reached the laboratory water bath turns on and off to maintain a constant temperature.